Introducing the the TBS Podracer AIO, the board is designed to cater for TBS Pro32 Nano VTX and TBS Crossfire / Tracer Nano RX with direct pin-header installation. The result is a clean, compact and lightweight core for your build.

The FC is equipped with F4 + MPU6000 and the ESC is capable of True 30A current running BLHeli32. This board is versitle enough to run on your cinewhoop, 4/5" racer like the podracer and longrange cruiser like the TBS Aureo.

FC side

Mounting holes: 25.5×25.5 mm / M2 holes
Crossfire/Tracer RX CH1&2 > Uart 2  /  Pro32 Nano VTX > Uart 1 / Uart 1(RX) - unavailable.
Up to 6S input
5V BEC up to 1.2A continuous
STM32F411 MCU (Support BetaFlight, EmuFlight)
MPU6000 Gyro/ACC
OSD chip Onboard (AT7456E)
2 available UART
LC Filter for 5V VTX and Camera
Direct solder connection for TBS Nano RX and TBS Unify Pro32 Nano
Support programmable LED like WS2812 etc
Built-in current sensor

ESC side

Signal support: PWM, Oneshot125, Oneshot42, Multishot, Dshot150, Dshot300, Dshot600
Input voltage: 2S-6S Lipo
Continuous current: 30A
Peak current: 35A
ESC firmware: BLHELI 32
PWM Frequency Range: 24KHz up to 96KHz

GPS Installation

Because of the phyiscal limitations, installing a GPS module to the FC will require a few extra steps to remap the board's resources.

Note: The follow steps will disable LED and FC's SmartAudio and use as softserial for GPS.

1. Flash the board with Target: STM32F411

2. Download the Config file [HERE]. Then load it the board.

3. Wire the GPS as shown

Includes

1 x TBS Podracer AIO
1 x Capacitor
1 x AWG cables set with shrink tubes
4 x mounting gromets
1 x XT60 (Male)
1 x XT30 (Male)
1 x Pinheaders set for TBS VTX and RX